The front derailleur tab on the Scott Foil is constructed of Carbon Fiber. What is the recommended torque for securing a braze on derailleur to the Carbon Fiber tab ?

35 in-lbs

Thank You.

35 in-lbs equates to 3.95 Newton Meters [N*m]

I have been in contact with Scott and here is what they recommend :

In their own words.

Shimano recommend for example 5-7 NM.

I would think 5Nm is enough at Foil. You can put some red carbon grease at the Carbon surface from the FD Hanger at the frame do avoid that the FD will twist during shifting. Please note it`s necessary to use the Carbon Washer which is included to all Frame sets.

I would recommend you to start with 3-4 Nm and would also put some blue Loctide at the thread.

In many places where CF and alloy parts are fixed together ,manufacturers give a torque of not more than 5NM to tighten parts.
Around stem face plates and carbon bars as well as carbon forks and stem fixing points. No different when clamping CF seat posts .
Always safe to treat bolts teeth with Loctite threadlocker.
So 5NM will be a very good figure for tighten your FD and use Loctite here as Vallron suggested.

Scott Foil seat post installation. Which type of carbon paste would be best suited for the job to help prevent seat post slippage, etc ?

Don't know if it's the best, but I used Finish Line's fiber grip and torqued only to 10NM. I have not had any issues with seatpost slippage on my Foil.

I washed the the Carbon paste of and lubricated the locking mechanism. That kept the post on its position.

Since this is a general thread about Scott foil. Anyone knows can we use 25mm tires especially on the front?

Yep, no problem with HED C2+25C tires.

Thanks

I used Park Tools carbon paste on my post. Lubed the other bits a little with white lightning toensure they slide easily.

Torque to about 8nm Max. It starts to make weird creaking noises above that, never had it slip. I know they say 12nm. But seems like the bolt or frame would snap.

Thanks a lot folks for the informative answers. Very helpful and much appreciated.

Like others said, the key to stopping the seatpost slippage is greasing the surfaces in between compression bolt for the post.

Scott Bikes recommend the use of special carbon grease of Scott, Syntace, Ritchey, or Motorex, for use on seatposts, stems and headset assembly.

Motorex Carbon Grease : http://motorexbicycle.com/mb/prod_detail.asp?id=25

Unique carbon assembly compound designed only for carbon bicycles. The compound is friction grease that is ideal for carbon/carbon or carbon/metal connections like seat posts. The unique feature of the MOTOREX CARBON GREASE is that it contains no particulates. Most friction greases have grit or particles to add friction. These particles will attack and compromise a carbon structure over time. The MOTOREX CARBON GREASE will not harm the carbon components or frames.