I am trying to finish up the build on my WW 29er and have a few things to get still. I was going to wrap my DS chainstay with an innertube cut down and wrapped around the chainstay right up to the BB. When I got the tube cut to the right length and made sure it worked, the inner weenie in my had to weigh it after and it was 48g. I thought there has to be a better and lighter option.

What is everyone using that is light and also protect the chainstay.

_________________
BIG DADDY B FLOW
AERO & LIGHT is RIGHT

Cervelo SLC 5890g/12.98 lbs

I use some black road handlebar tape, cork one, light!

_________________
My steel XPREZO 29er race bike
­Twitter
My blog --- http://www.cyclingtrainingnuts.blogspot.ca

do you run it along the top and then wrap the rest with electrical tape?

_________________
BIG DADDY B FLOW
AERO & LIGHT is RIGHT

Cervelo SLC 5890g/12.98 lbs

Just electrical tape across the top

_________________
For certain parts stiffer is more important than lighter.

Shelter tape

http://sealwrap.com/

Found out about this on mtbr forum ... and literally just wrapped my old Ti 26" this morning (building it back up with XX1 and a rigid DT Swiss fork). Works great, stretches as thin as you like, and a lot lighter than an old tube.

_________________
My Ride - Parlee Z5

Go to a mtorbike shop and get frame tape/scuff tape. Should weigh about 6g when you are done.

_________________
Used to race....got too wrinkly and old Updated: Racing again! Thought this was unlikely! Eventually, I may even have a decent race!

nope

I wrap the chainstay like I wrap a handlebar, its cleaner that way, you dont need a lot of tape, so its still quite light and subtle.

_________________
My steel XPREZO 29er race bike
­Twitter
My blog --- http://www.cyclingtrainingnuts.blogspot.ca

I am using foam wrap arounds with velcor fastening, off ebay from china - much lighter than the ones that come on the bike.

... and they are cheap too.

here is one that was altered to fit a narrower chainstay.

Im using self amalgamating rubber tape. (kinda like a light weight and neater version of the inner tube idea) the rubberised tape bonds to itself and does not bond to the frame.

I am using an old shark fin. I don't know what it weights for real but the list shows it at 4 grams I think its probably more than that.

I use this in my bikes.

http://store.lizardskins.com/products/c ... -chainstay.

The other bikes I use the ones came already preglued or installed by the frame manufacturer.

_________________
http://www.hackracer.com/

transparent 3M vinyl. Available in several thicknesses. They also sell under the brand Bike Shield.

I used to use a tube. Now I either use 3m vinyl tape on roadies... for mtbs I use a hutchinson fusion 3 tire that was punctured and then I cut off the beads... like the tube, but totally next level.