Hey folks!

I just noticed today that my front Reynolds DV46 UL rim us has warped around the nipples in at least 5 different locations. This wheelset was one of the first batches that came out, those ones that were around 1180gr.

Anyhow Ive been riding them for 3 years without even noticing any defects and they are strangely still true.

So just wanted to ask your wise opinion on whether you think they are safe to ride or not?

_________________
Canyon Ultimate SLX 2013 + DA9070 + Red Quarq + Corima Aero+ MCC (Ordered! 6.0kg)
Canyon AeroRoad + DA9000 + Lightning Power2Max + MCU's (6.5kg)
Cervelo P4 + G3 Powertap (7.78kg)
Cervelo SLC + SRAM Red 2013 + Red Quarq (6.8kg)

I have a set of alloy rims that have done that (they pop out instead of in) I spoke to my LBS about it, they said I should just ride it till it fails Not sure what thats supposed to mean

_________________
Apparently my bikes were talking the other day & are undecided whether to upgrade the current rider or get a new one...

one of the schemers...

Send the pictures to Reynolds and see what they day.

_________________
www.ergottwheels.com

this is something that reynolds cannot argue against, just be glad they aren't carbon, or you might have noticed it at the wrong time!

_________________
No, I am not trying to sell you something.

+1

As long as these are a Reynolds stock build and haven't been over-tensioned by a ham-fisted "mechanic" then i suspect Reynolds will be receptive...Reynolds is known for being quite good at backing their product. EM3

_________________
________________

My 2011 Cervelo R5

What?
Sure that they are not carbon?

Well, a mate had the same with his 32UL 's.Had them only for 4700 kms on his bike. He kept on riding with them. The next step are spoke failures. Spokes brake just at the internal nipple edge. Therefore be prepared for deep scratches in your carbon frame inside your chain stays and or seat stays.
I would not ride with them any further.

So this is an "high end non Chinese component failure" then.

Thanks for the reply folks! I'll definitely send Reynolds an email asking their opinion on the matter. I dont expect to get any replacement from them as the wheelset is almost 4 years old. Its just sad that once they realized that this lighter version wasnt strong enough they didnt recall the ones that had already shipped out.

I dont think Ill ever buy a Reynolds wheelset again. Not only because of this issue. The drilled holes on the rim seem to strip everytime you replace a tire. Ive seen the same thing happen on on my SDV66's so its a general thing.

_________________
Canyon Ultimate SLX 2013 + DA9070 + Red Quarq + Corima Aero+ MCC (Ordered! 6.0kg)
Canyon AeroRoad + DA9000 + Lightning Power2Max + MCU's (6.5kg)
Cervelo P4 + G3 Powertap (7.78kg)
Cervelo SLC + SRAM Red 2013 + Red Quarq (6.8kg)