here just one photo from a few days ago, PT5 in process. Sorry for the bad photo quality, right now I can't really make another better photo because water is all around, we have some floods in Slovenia and a lof of rain these days...
As you can see on this photo still some more sanding to do. Then I only need to cut the seatpost tube a bit, put on some cable stops and lacquer it. If I'm honest I didn't decided yet how I'll make it, but when I look at my PT4 I think that I'll just keep that look from PT4, and put some stickers over the clear coat. That way I can change them any time I want, and as long as it's a prototype, why not
. Otherwise I could also paint it, will see how I'll decide...
..anyway, also the rainy days have a good side
, and there can be done some more work in SolidWorks:
still some more work to do, but just to show you how it should look. It's for BB30 press-fit bearings,..will make some other pictures from different angles as soon as the frame is completely designed
As you can see from those SolidWorks pictures I keep my design, only a bit improved it because the monocoque procedure allows me that. So the tubes have a slightly different shape (especialy when it meets the joint) etc.,..
_________________Berk PROTO-TYPE Composites - Handmade In SloveniaBerk Compositeshttp://www.berk-composites.com/