Something to think about before you Loctite bearings,adaptors or sleeves into a carbon frame is that the standard way for disassembly of most Loctite bearing and stud mounts is applying heat. In the case of Loctite 609 and 641 250º C. See the TDS :http://media.midwayusa.com/pdf/instruct ... te_609.pdf
" onclick="window.open(this.href);return false;" onclick="window.open(this.href);return false;" onclick="window.open(this.href);return false;" onclick="window.open(this.href);return false;
Do you want to heat your carbon frame up to that temp? I wouldn't on mine. Many manufacturers tell you not leave your frame in a closed car on a hot day! Just like your dog, it may die.
I was skeptical when Trek brought out the all carbon BB and am even more so now that I see they have special oversize bearings and shims for out of tolerance bottom bracket moulding.
The TDS also says that Loctite 609/641 is not recommended on thermoplastics. The fact that it may be recommended by various manufacturers leads me to assume that these designs are having service issues. I work in the automotive industry and most of the gap filling/sleeve retaining Loctite type products require heat and or quite a bit of force to take them apart. Pounding or rigging up an elaborate puller on a lightweight bottom bracket with little material to begin with seems like asking for trouble.
However, you may be left with little choice but to use these products so you have a useable crank/bearing assembly. But it may make for a trashed frame when it comes time to replace the bearings.