I've got PowerCordz Prime cables and housings on my ee brakes but suspect that other housings might work better (less drag) than the PC housings. Does anyone have succcessful experience mixing PC Prime brake cables w/other housings, ie I-Links, Jagwire, etc.?

How about for derailleur cables: any positive experience using other brand housings w/PC cables?

Cheers,

John

_________________
Wilier Cento Uno, 13.25 lbs / 6.01 kilograms
http://weightweenies.starbike.com/forum/viewtopic.php?f=10&t=95887

I bought the Powercordz Nokon Liners from Fairwheel to use with my Nokon Cable Set and they seem to work well. I think you could probably use it on other cable systems though I am not sure. Ultimately, I ended up going back to steel cables because I could not get the Powercordz to fasten well enough to my EE Brakes. I tried the little blue rubber groumets but could not get it to work to my satisfaction. If you come up with a better solution I would love to hear about it. Mark

as above, nokon

the nokon liner is way better than the powercordz one, especially for the brake cables

While ago I had PC working with Nokon on my mtb bike, no issues.
Recently I've been using PC with Jagwire housing (brakes and dlrs) on road bike, with no issues.
Now I am on PC paired with Niro alloy housing and as above it works fine.

_________________
Cervelo R5 VWD 5637g/12.43lb
Cannyon Ultimate slx 5592g/12.33lb
Pronghorn XC SW Race 8284g/18.26lb

hang on a sec, i must've had my brain in neutral when i posted the above

the powercordz nokon-compatible liner is the good one (was transparent blue, i think it's now transparent yellowish), it's the stock nokon liner that is poor (black stuff, tight, and gets kinked inside the nokon segments over time)

so just to be clear, that's pttthhbbb to nokon liner, and hurrah for powercordz liner

I suggest trying out the Alligator iLinks. I have used both iLinks and Nokons and I find the iLinks a lot easier to work with.

I found that the Power Cordz outer worked very nicely- in back to back (literally, the rear brake is still using iLink housing) testing there is noticeably less drag with the PC housing than the Alligator iLink, 7970 levers to EE brakes.