my cervelo from France
Moderators: MrCurrieinahurry, maxim809, Moderator Team
in add , the new sram red is very hard to lightnen
you can't put carbon clamp without machining the body
original mech plate from rear derailleur are ligh too
I just hope that btp will make some carbon hoods
after that I will see if I machin the shifter or not
you can't put carbon clamp without machining the body
original mech plate from rear derailleur are ligh too
I just hope that btp will make some carbon hoods
after that I will see if I machin the shifter or not
Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓ Broad Selection ✓ Worldwide Delivery ✓
www.starbike.com
-
- Posts: 3496
- Joined: Sat Jan 06, 2007 9:47 pm
- Location: Pittsburgh
Steff...this is one of my favorite bikes on the forum. Congrats
rear derailleur
carbonschmiede mech plate, extralite pulley, schmolke carbon pulley screws,carbon stop machined screws
front wheel
I bought tune carbon rear axle
I machined it and machined carbon washer to maintain the bearings
original axle
my axle
rear wheel
carbonschmiede mech plate, extralite pulley, schmolke carbon pulley screws,carbon stop machined screws
front wheel
I bought tune carbon rear axle
I machined it and machined carbon washer to maintain the bearings
original axle
my axle
rear wheel
Last edited by steff on Tue May 08, 2012 4:11 pm, edited 2 times in total.
-
- Posts: 3496
- Joined: Sat Jan 06, 2007 9:47 pm
- Location: Pittsburgh
Steff,
Is that a confirmed weight or did you just add up the individual components?
Is that a confirmed weight or did you just add up the individual components?
4,41kg...
C'est quand même pas rien...
C'est quand même pas rien...
Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓ Broad Selection ✓ Worldwide Delivery ✓
www.starbike.com