Greetings fellow weenies. I recently discovered that a small part of the tread has become unstuck from the casing, about 9cm, as shown in the photo. I use it as a race only tyre, rear, with about 1500km on it. I can get another 1500km out of it for sure, so it would be a shame to throw it away without a fight!! So my question is, can i somehow glue it without any safety issues? What kind of glue would you use, if so? Or maybe some other idea that could help. Thank you all!

_________________
mortal engines

A terrible idea. Burn the damn thing ASAP.

Nursing damaged tires is the worst place to try and save a few dollars.

_________________

Email veloflex they would most Likley replace the thing

_________________
http://fairwheelbikes.com/c/forums/topi ... parlee-z5/

Hi,



Clean the entire area with some alcohol, let evaporate then use the same glue you'd repair a flat inner tube with. Put some on both the tread and the tyre proper and let it cure for a few minutes.

Put the tread back where it ought to be and apply some pressure untill both parts stick firmly together. Let it sit for a few hours and that's the end of that.

Ciao,

_________________
Being a snob is an expensive hobby.

Thanks! You mean something like this right? http://www.worldofbike.gr/en/bike-maint ... -velox.htm
I have also sent a mail to veloflex, lets see what they respond!

_________________
mortal engines

Hi,

Yes, that's the kind of glue you'd want. Not sure about the quality of the Velox one though. There's much better around.

Ciao,

_________________
Being a snob is an expensive hobby.