My Speedplay Ti inserts are ready to be made, but...
Moderator: robbosmans
WILL ANYONE BUY THEM? I've got the protoypes finished and they are sweet. Weight savings of 12g, and pretty much good forever. Only bad news is the smallest quantity that I can make them is in a set of 20, or about $900. So... If I'm gonna make these I need to know if people will buy them. 900 is a lot for such a small bike part. Just to get them going I'll sell them only slightly above cost, about $60 a pair. If I can get 20 people to buy then they will become a reality. Any input much appreciated. If I get enough interest in them I'll put them on ebay. Thanks for your help!
Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓ Broad Selection ✓ Worldwide Delivery ✓
www.starbike.com
I hate to burst your bubble, but BTP in germany has been selling these for some time now, and there is an importer already in the USA.
Good luck, and I hope you are successful. Realistically, a product this simple shouldn't be that expensive.