9 speed cassette on a 8 speed rig?

Discuss light weight issues concerning mountain bikes & parts.

Moderator: Moderator Team

Post Reply
Mattgecko
Posts: 10
Joined: Fri Jan 30, 2004 8:16 pm
Location: California

by Mattgecko

Can I use a 9 speed cassette on my 8 speed set up?

My current cassette is warn and needs to be replaced. I'd like to slowly upgrade the parts to a 9 sp.

Can I adjust the derailer so it doesnt use the smallest gear?

Sorry about the stupid question, I don't want to waste $80-$100 on another XTR M950 if I can slap on a M960.

User avatar
Frankie - B
Admin - In the industry
Posts: 6573
Joined: Mon Jun 02, 2003 8:17 am
Location: Drenthe, Holland

by Frankie - B

No, you can't

9 speed uses smaller cogs. The chain has to be smaller too. Better save a bit longer and get yourself the full setup!
'Tape was made to wrap your GF's gifts, NOT hold a freakin tire on.'
If you want to see 'meh' content of me and my bike you can follow my life in pictures here!

by Weenie


Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓    Broad Selection ✓    Worldwide Delivery ✓

www.starbike.com



Mattgecko
Posts: 10
Joined: Fri Jan 30, 2004 8:16 pm
Location: California

by Mattgecko

OK


When I do upgrade everything to 9 speed, will I have to also replace my front gears (race face, 22T, 34T, 46T)?

User avatar
Frankie - B
Admin - In the industry
Posts: 6573
Joined: Mon Jun 02, 2003 8:17 am
Location: Drenthe, Holland

by Frankie - B

no, not necesary :smartass: only rear mech, chain and rearshifter. Most modern rings are already smaller.
'Tape was made to wrap your GF's gifts, NOT hold a freakin tire on.'
If you want to see 'meh' content of me and my bike you can follow my life in pictures here!

Mattgecko
Posts: 10
Joined: Fri Jan 30, 2004 8:16 pm
Location: California

by Mattgecko

Thanks again for the schooling. :D This place has all the answers.

jermans
Posts: 44
Joined: Mon Nov 17, 2003 4:32 pm

by jermans

It is possible to change from 9 speed to 7 speed but not 8.

User avatar
Frankie - B
Admin - In the industry
Posts: 6573
Joined: Mon Jun 02, 2003 8:17 am
Location: Drenthe, Holland

by Frankie - B

:?: 7 speed uses a shorter body. :?
'Tape was made to wrap your GF's gifts, NOT hold a freakin tire on.'
If you want to see 'meh' content of me and my bike you can follow my life in pictures here!

danielgillett

by danielgillett

You can use 9 speed chainrings with 8 speed. But you can not use 8 speed chainrings with 9 speed.

User avatar
Frankie - B
Admin - In the industry
Posts: 6573
Joined: Mon Jun 02, 2003 8:17 am
Location: Drenthe, Holland

by Frankie - B

that's chainrings, not cogs?
'Tape was made to wrap your GF's gifts, NOT hold a freakin tire on.'
If you want to see 'meh' content of me and my bike you can follow my life in pictures here!

by Weenie


Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓    Broad Selection ✓    Worldwide Delivery ✓

www.starbike.com



User avatar
martin
Posts: 947
Joined: Wed Nov 27, 2002 9:49 am
Location: München
Contact:

by martin

danielgillett wrote:You can use 9 speed chainrings with 8 speed. But you can not use 8 speed chainrings with 9 speed.

? sure you can. Buddy of mine uses an ancient TA-crank (when that was built it was still the time of friction-shifted 7spd) with Campagnolo 10-speed without any problems.
I run a Campa 10-speed setup with a 9-speed DA chain and a FSA Shimano 9-speed crank.

That whole compatibility is a little overrated, if you ask me. There are issues, but they concern shifters, rear derailleur and cogs.
There may be exceptions, but cranks are typically not a problem.

Martin
Snowman and Strong Walker
Scott Sc
my old stuff
my new stuff

Post Reply