Its not that hard. If you want the Enve logos removes, use some semi fine paper (320) Top it of with something at +600. Then clean the post with acetone. Don't touch the carbon, and then spray with some clearcoat. The 2 things that can go wrong is A) Clearcoat will crumble. Usually because of fingerprints or any other dirt. B) Too much spraying will make the coating drip. Making waves on the surface. Do the clearcoat over 2 or 3 times instead of one heavy spraying.
Edit: And some clearcoat comes with glimmer. Unless you really like it, you should avoid those.
Thanks for this. If I don't want to remove the Enve logos, how best to clean the post prior to applying the clear coat. (I assume using acetone will remove the logos.)