DA9000 Front Derailleur Spring Tension
Moderator: robbosmans
I've been having some trouble with my DA9000 FD where it doesn't shift under heavy load (e.g. out-of-the-saddle climbing on the big ring and shifting to small ring). It seems like there isn't enough spring tension to shift it over when there is higher chain tension - I have to let up a bit to get it to shift.
Is this a faulty derailleur or is there some way to address this?
Is this a faulty derailleur or is there some way to address this?
Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓ Broad Selection ✓ Worldwide Delivery ✓
www.starbike.com
-
- Shop Owner
- Posts: 1980
- Joined: Sat Jun 13, 2009 4:02 am
- Location: NoVA/DC
What chain, what crankset/chainrings?
Sent from my EVO using Tapatalk 4
Sent from my EVO using Tapatalk 4
Oddly enough I had to use more front cable tension then I did with 7900. Works like a charm now.
what frame? I didnt put a barrell adjuster in and was a bitch to setup that said its sorted now. did you use the cable guide tool to ensure the cable was routed into the mech the correct way as there are two ways to route cable?
Madone Five Series 2013
Shimano Dura-Ace 9000
Mavic Cosmic SLE 2013
Shimano Dura-Ace 9000
Mavic Cosmic SLE 2013
dallyride wrote:All standard DA9000 with 52/36 chainrings. Cables are brand new... (will check the BB guide)
Can't see how more cable tension would help. Wouldn't it be the opposite?
No, the shift should be snappy and fast. I wasn't getting the top trim position until I used a 2nd hand tool to take some cable tool slack. When its in the lowest trim position very lightly click it once. if it doesnt move into the 2nd position noticeably and produce chain rub in little/little then there is not enough tension. This is what was happening to me, but when diagnosing it I kept swiping to the big ring all the way and couldn't figure it out.
The rotation setup was more crucial for chain rub and trimming.
bmxbandit wrote:^That, also check the fd is correctly aligned in terms of height and rotation.
Even though it looks to be installed correctly,it may be a bit too close and not have enough leverage to shift the chain. It may need to be moved up a tad.
Will test it out. Thanks for the suggestion.
-
- Posts: 33
- Joined: Fri Feb 03, 2012 9:10 am
You need to put more tension, the 11 speed front derailleurs need a lot tension.
Another vote for tension.
I have been running the FD9000 since April, and set it up myself, rather than having the shop do it. The whole 9000 groupset is very sensitive to small errors in alignment and tension.
I fitted a barrel adjuster which was basically essential to get the tension dialed high enough for decent functionality.
I have been running the FD9000 since April, and set it up myself, rather than having the shop do it. The whole 9000 groupset is very sensitive to small errors in alignment and tension.
I fitted a barrel adjuster which was basically essential to get the tension dialed high enough for decent functionality.
Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓ Broad Selection ✓ Worldwide Delivery ✓
www.starbike.com
Turn down the suck knob.