MTB on Turbo Trainer

A light bike doesn't replace good fitness.

Moderator: Moderator Team

Post Reply
Posts: 44
Joined: Sun Jan 15, 2012 2:25 pm

by tomgag

Hi there Guys,

I have a few question regarding running a turbo trainer with a mountain bike.

Do I need a special type of turbo trainer or will any one do or the adjustment (up/down) will be enough??

I understand that i need to change tyre from a knobbly one to a slick but do you have any suggestions for what slick to get or should I use turbo trainer special tire (if any exists)

Any thing else that i need to do/ get to be able to run it.

All help appreciated


Posts: 1037
Joined: Fri May 02, 2008 5:39 pm
Location: Here, there and everywhere

by DanW

As far as I am aware any turbo trainer should be fine.

I use a Continental Tyre dedicated for turbo trainer use. They are the only company producing such a thing as far as I know. It is a large volume tyre so the diameter isn't too different to the diameter of a road tyre on a 700cc wheel and hence adjustment is no problem. I also find quieter and hard wearing. Most (all?) turbo trainers should also be able to run a very thin 1 inch road style tyre in a 26 inch size (hence smaller wheel diameter) with an adapter bracket which should be included with the turbo.

by Weenie

Posts: 1606
Joined: Wed Mar 28, 2007 12:49 pm
Location: Near Horgen, Switzerland

by mrfish

My old Tackx uses a screw to reposition the resistance unit. It came with some extra plastic bits to move the resistance unit up to meet a 26" tyre. So check before you buy. I guess it would depend a bit on the tyre as well, as diameter would vary a bit between an the extremes of an 18mm time trial tyre and a shaved 2.5" mtb tyre.

Post Reply
  • Similar Topics
    Last post