Stretching an alloy frame...

Especially for light weight issues concerning cyclocross / touring bikes & parts.

Moderator: Moderator Team

Post Reply
Raouligan
Posts: 14
Joined: Thu Dec 30, 2010 4:29 pm

by Raouligan

Ok so I've got an unused Voodoo Limba with disk bosses on the sliding dropouts and 130mm spacing I had it built up with cantilevers ages ago.

What are peoples thoughts on forcing a 135mm wheel in? If it was steel I'd just bang it in and not even worry about it!

by Weenie


User avatar
monty dog
Posts: 127
Joined: Mon Jan 26, 2004 7:48 pm

by monty dog

If there's enough 'springiness' in the frame you might get away with it, but anything that requires you to set or permanently distort the frame will likely cause a weakness and decrease the expected life of the frame. Most aluminum/aluminium alloys have a very small plastic-deformation tolerance - go beyond it and cracks start appearing.
Just ride

Post Reply
  • Similar Topics
    Replies
    Views
    Last post