SiSL2 + SRM
Moderator: robbosmans
-
kentbrockman
- Posts: 33
- Joined: Fri Feb 08, 2008 11:37 pm
- Contact:
Anyone running the new Cannondale SiSL2 crank with an SRM? Still need the old SRM specific BB and Spindle?
Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓ Broad Selection ✓ Worldwide Delivery ✓
www.starbike.com
See this thread viewtopic.php?f=3&t=106934 and this thread viewtopic.php?f=3&t=104236&start=105.
Until someone actually does it or Cannondale/SRM themselves confirm (which I'm still waiting on, a week and a half after contacting them) than it's still uncertain as to what setup works.
Until someone actually does it or Cannondale/SRM themselves confirm (which I'm still waiting on, a week and a half after contacting them) than it's still uncertain as to what setup works.
-
kentbrockman
- Posts: 33
- Joined: Fri Feb 08, 2008 11:37 pm
- Contact:
Yeah, I saw those threads. Was hoping someone has actually connected the dots, but so far no love.
Looks like the new spindle is 109mm, so there *should* be room for the SRM, but that's a $2000 bet. Lemme know if/when you hear back.
Looks like the new spindle is 109mm, so there *should* be room for the SRM, but that's a $2000 bet. Lemme know if/when you hear back.
Just to confirm, you can run a Cannondale SRM with the new SI SL 2 crankarms. I am using the Mk V Cannondale rings on Campy 11 and it all works perfectly.
I used the Campy SL 2 Ceramic BB. The SL2 uses a 109mm spindle for a slightly different q-factor.
I used the Campy SL 2 Ceramic BB. The SL2 uses a 109mm spindle for a slightly different q-factor.
