Page 1 of 1
Power Arms and JIS bottom bracket
Posted: Wed Sep 03, 2003 1:30 am
by Superlite
Does anyone know how stiff the power arms are? Stiffer then FSA cranks or Dura ace? Also Is the JIS interface very good. hows the stiffness compared to an ISIS or octalink interface? Also does it squek alot? Thank you.
Power Arms and JIS bottom bracket
Posted: Wed Sep 03, 2003 1:30 am
by Weenie
Visit
starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓ Broad Selection ✓ Worldwide Delivery ✓
www.starbike.com
Posted: Wed Sep 03, 2003 9:21 am
by Francois_viviers@hotmail.
They are plenty stiff enough compared to FSA carbon pro or Dura ace, if you are buildin a ridiculousy light bike sometimes it is hard to pinpoint stiffness as they seem to respond so much quicker. Word of warning though if you are going for Square taper, then just make sure about the taper of the cranks. I have Storks in Shimano bolt pattern but the taper is iso not jis. I tried it on a jis BB and it does not go far enough
Posted: Wed Sep 03, 2003 10:30 am
by Florian
Francois_viviers@hotmail. wrote:Word of warning though if you are going for Square taper, then just make sure about the taper of the cranks. I have Storks in Shimano bolt pattern but the taper is iso not jis. I tried it on a jis BB and it does not go far enough
On what BB did you install them?
For the Power Arms Pro you need a 104 mm axle.
And AFAIK at 104 mm the ISO taper is compatible with the JIS taper.
So you can mount JIS cranks on 104 mm ISO BBs and ISO cranks on 104 mm JIS BBs.
Posted: Wed Sep 03, 2003 12:38 pm
by Francois_viviers@hotmail.
Thanks mate
You learn something new everyday
Posted: Wed Sep 03, 2003 3:59 pm
by Superlite
So which bottom bracket and what type of taper should I go with? What do you guys ride? Thanks.