Power Arms and JIS bottom bracket
They are plenty stiff enough compared to FSA carbon pro or Dura ace, if you are buildin a ridiculousy light bike sometimes it is hard to pinpoint stiffness as they seem to respond so much quicker. Word of warning though if you are going for Square taper, then just make sure about the taper of the cranks. I have Storks in Shimano bolt pattern but the taper is iso not jis. I tried it on a jis BB and it does not go far enough
Francois_viviers@hotmail. wrote:Word of warning though if you are going for Square taper, then just make sure about the taper of the cranks. I have Storks in Shimano bolt pattern but the taper is iso not jis. I tried it on a jis BB and it does not go far enough
On what BB did you install them?
For the Power Arms Pro you need a 104 mm axle.
And AFAIK at 104 mm the ISO taper is compatible with the JIS taper.
So you can mount JIS cranks on 104 mm ISO BBs and ISO cranks on 104 mm JIS BBs.
-
- Similar Topics
- Replies
- Views
- Last post
-
- 3 Replies
- 633 Views
-
Last post by JScycle
Tue Oct 31, 2017 7:56 am
-
- 7 Replies
- 939 Views
-
Last post by JScycle
Sat Jul 15, 2017 1:11 pm
-
- 1 Replies
- 569 Views
-
Last post by micky
Wed Oct 04, 2017 8:53 am
-
- 13 Replies
- 1318 Views
-
Last post by Y26
Tue Jul 25, 2017 6:09 pm
-
- 11 Replies
- 1274 Views
-
Last post by Calnago
Sat Jun 24, 2017 3:03 pm