Ti bolt For Campy Seat Post Clamp

[zoey]

Okay I admit it I'm lazy... I have a Campy seatpost binder and I'm looking for a TI bolt for it. Can anyone tell me what size I'll need?

Thanks in advanced.

[Carltontwin]

M6 X 1mm Pitch X 20mm long, and the diameter of the head needs to around 9.5mm or there may be some clearance issues in the counterbore of the clamp.

[zoey]

Thanks Carltontwin! I'll see if I can source a Ti bolt for it.

[tommasini]

I could not find Ti bolts with the slightly smaller head size needed so I carefully chucked the bolt into a drill press and as it spun around sanded the head to the slightly smaller size. Not removing much - just "enough"

[J xl]

Did the same but titanium is critical here since the special clamp needs at least 9 nm and the bold in this size should hold about 7 nm. Still not sure if titanium is wise for this purpose (will show in time)

[asphaltdude]

Sneeze twice before every ride and you'll save the same amount of weight for free

[zoey]

Sneeze twice before every ride and you'll save the same amount of weight for free

I only have one bolt left that is not Alum or Ti on my bike. I've gone this far so no turning back for this WW.