How dirty does your chain get?

Discuss light weight issues concerning road bikes & parts.
evan326
Posts: 480
Joined: Wed Sep 14, 2016 8:51 pm
Location: RVA,USA

by evan326

I've had good results with pro link gold. As long as you wipe the chain very well after applying, it stays clean for me.

by Weenie


oldturd
Posts: 76
Joined: Thu Oct 06, 2016 12:10 am

by oldturd

CrankAddictsRich wrote:I use Molten Speed wax....

Chain and cogs are always clean to the touch. It is a little bit more work in the beginning to strip your chain (if it's used, of the old lube... or if it's new, of the factory grease) and cogs (if they're used), but after that, I'd say its a pretty even in terms of time invested to re-wax. I use 2 chains, so one is already waxed, ready to swap on and then I can re-wax the one that comes off at my leisure. I'm getting about 600-650 miles between re-applications. I could stretch it more if I really wanted to.



i'm likely doing it wrong so looking for your feedback since your bike looks immaculate.. i get a lot of excess wax build up and wax debris all over the frame and chain. any tips?

bilwit
Posts: 438
Joined: Sun Apr 03, 2016 5:49 am
Location: Seattle, WA

by bilwit

TobinHatesYou wrote:Gold and Extreme are almost exactly the same for me. Neither pick up dirt, but they don’t last me more than about 200mi either.


Same, I usually end up just using Extreme. It might pick up more dirt than Gold but I clean it frequently enough to not really notice the difference. When it rains, I use it the night before, clean it when I get back and then dry, re-apply. Between dry days I'll do the same except every other ride or two.

Boshk
Posts: 192
Joined: Wed Jul 19, 2017 2:59 am

by Boshk

thanks for all the recommendations. I'll see if I can get my hands on some R&R Gold lube and then just clean/degrease the whole drive train and start again with R&R lube.
Oltre XR3, Diverge DSW

CrankAddictsRich
Posts: 780
Joined: Wed Jan 27, 2016 1:39 pm
Contact:

by CrankAddictsRich

oldturd wrote:
CrankAddictsRich wrote:I use Molten Speed wax....

Chain and cogs are always clean to the touch. It is a little bit more work in the beginning to strip your chain (if it's used, of the old lube... or if it's new, of the factory grease) and cogs (if they're used), but after that, I'd say its a pretty even in terms of time invested to re-wax. I use 2 chains, so one is already waxed, ready to swap on and then I can re-wax the one that comes off at my leisure. I'm getting about 600-650 miles between re-applications. I could stretch it more if I really wanted to.



i'm likely doing it wrong so looking for your feedback since your bike looks immaculate.. i get a lot of excess wax build up and wax debris all over the frame and chain. any tips?



uhhh... wipe it off. What you're describing is just the excess wax on the outer areas of the chain flaking off as the chain flexes. You can simply wipe it off. My bike normally has it too, but since I was taking some professional level pics of my bike, I wiped it off. The was that's important, is the wax inside the rollers of the chain.
2016 Pactimo Brand Ambassador
http://www.Crankaddicts.cc
http://www.skratchlabs.com
2015 Specialized S-Works Allez
2015 Specialized Venge Pro
2014 Specialized S-Works Shiv TT

User avatar
Lelandjt
Posts: 368
Joined: Tue Jan 19, 2016 7:10 am

by Lelandjt

I wonder why Finishline Krytech isn't more popular. My chains don't get dirty and last longer than other people's.

TheKaiser
Posts: 442
Joined: Thu Sep 05, 2013 3:29 pm

by TheKaiser

CrankAddictsRich wrote:uhhh... wipe it off. What you're describing is just the excess wax on the outer areas of the chain flaking off as the chain flexes. You can simply wipe it off. My bike normally has it too, but since I was taking some professional level pics of my bike, I wiped it off. The was that's important, is the wax inside the rollers of the chain.


Two questions:

1. When you say "wipe it off" are you saying wipe the excess over time, as it comes off on various parts of the bike, or are you saying to wipe it off when you remove the chain from the wax bath, in order to prevent the excess being there in the first place?

2. Doesn't the temp of the wax when you remove it from the bath also make a difference in the amount of excess on the outside? I recall seeing talk of some people removing the chain from the wax bath and letting it drip off when the wax was still at peak temps, whereas other people were letting the wax get gooey before removing the chain. The consensus was that the first method was much cleaner in terms of excess wax, but that some of the wax inside the rollers may also drip out, as it is so fluid at that point, so the application may not last as long.

kode54
Posts: 1102
Joined: Tue May 23, 2006 9:39 pm

by kode54

CrankAddictsRich wrote:I use Molten Speed wax....

Chain and cogs are always clean to the touch. It is a little bit more work in the beginning to strip your chain (if it's used, of the old lube... or if it's new, of the factory grease) and cogs (if they're used), but after that, I'd say its a pretty even in terms of time invested to re-wax. I use 2 chains, so one is already waxed, ready to swap on and then I can re-wax the one that comes off at my leisure. I'm getting about 600-650 miles between re-applications. I could stretch it more if I really wanted to.

Image

Image


ditto. not sure if i can get 600 miles...but definitely can get about 400. less work for me to maintain the clean drive train.
- AX Lightness Vial EVO D + DA9150 + Enve SES 3.4 carbon hubs
- Parlee Altum + DA9150 + Enve SES 4.5 carbon hubs
- Parlee ESX + DA9150 + THM SRM PM + Enve SES 6.7 CK hubs
- Independent Fabrication Ti FLW + DA9100 + Enve 3.4 CK hubs

TobinHatesYou
Posts: 622
Joined: Mon Jul 24, 2017 12:02 pm

by TobinHatesYou

That really is the key with any dry lube, whether it’s Teflon/PTFE lubes or wax-based. Give it a a few hours to fully dry after wiping all of the excess from the outer links and outer surface of the rollers. Don’t forget to clean off any gunk previously deposited on the rest of the drivetrain.

Doesn’t matter if it’s Dumonde, MSW, RnR, Muc-Off C3, or whatever. They’re all going to be very clean if treated like this.

Allen254
Posts: 119
Joined: Sun Feb 07, 2016 3:05 am

by Allen254

I have a friend who some hows manages to never get his chain all dirty like mine dose. I think its cause I'm to lazy to clean regularly.

CrankAddictsRich
Posts: 780
Joined: Wed Jan 27, 2016 1:39 pm
Contact:

by CrankAddictsRich

TheKaiser wrote:
CrankAddictsRich wrote:uhhh... wipe it off. What you're describing is just the excess wax on the outer areas of the chain flaking off as the chain flexes. You can simply wipe it off. My bike normally has it too, but since I was taking some professional level pics of my bike, I wiped it off. The was that's important, is the wax inside the rollers of the chain.


Two questions:

1. When you say "wipe it off" are you saying wipe the excess over time, as it comes off on various parts of the bike, or are you saying to wipe it off when you remove the chain from the wax bath, in order to prevent the excess being there in the first place?

2. Doesn't the temp of the wax when you remove it from the bath also make a difference in the amount of excess on the outside? I recall seeing talk of some people removing the chain from the wax bath and letting it drip off when the wax was still at peak temps, whereas other people were letting the wax get gooey before removing the chain. The consensus was that the first method was much cleaner in terms of excess wax, but that some of the wax inside the rollers may also drip out, as it is so fluid at that point, so the application may not last as long.



1. I mean wipe off the excess that has flaked off the chain.

2. I follow the instructions on the molten speed wax website... I get the wax to 195* F, unplug the slow-cooker and then dunk the chain in and agitate it for 45 second to a minute. When I pull the chain out, the wax is wet, but usually begins to dry harden within a few seconds. I hang the chain in my basement, so its ready to go on when I need it.
2016 Pactimo Brand Ambassador
http://www.Crankaddicts.cc
http://www.skratchlabs.com
2015 Specialized S-Works Allez
2015 Specialized Venge Pro
2014 Specialized S-Works Shiv TT

Post Reply
  • Similar Topics
    Replies
    Views
    Last post