BB30 circlips when fitting BB30-24mm Bottom Bracket

Discuss light weight issues concerning road bikes & parts.
Post Reply
thepainandsuffering
Posts: 14
Joined: Fri May 15, 2015 11:26 pm

by thepainandsuffering

Hi

I am about to fit this BB30 to 24mm bottom bracket Into a Cannondale with a BB30 shell.

https://www.sjscycles.co.uk/bottom-brac ... oad-68-mm/

The one thing I am unsure on is do I need to leave the circlips that sit behind the BB30 bearings in place or remove them before fitting. My inclination is that they stay put but they are not mentioned in the basic fitting instructions that are included with the BB and would like some advice before I get it wrong.

Any help would be most welcome.

Thank you.

N

by Weenie


User avatar
bikerjulio
Posts: 1901
Joined: Fri Dec 11, 2009 10:38 pm
Location: Welland, Ontario

by bikerjulio

Looks to me like you definitely need to remove the clips. They are there to act as a stop for a BB30 bearing.

That adapter BB needs to bear against the outside of the BB shell, not the clips.

The clips may or may not interfere with the new BB, it's hard to tell, but why risk it?
There's sometimes a buggy.
How many drivers does a buggy have?

One.

So let's just say I'm drivin' this buggy...
and if you fix your attitude you can ride along with me.

http://www.youtube.com/watch?v=GekiIMh4ZkM

hambini
Posts: 113
Joined: Tue Nov 15, 2016 8:13 am

by hambini

You need to remove the circlips/snap rings

You must make sure the face of your bottom bracket shell is flat and smooth otherwise you'll have problems

Hambini

Post Reply
  • Similar Topics
    Replies
    Views
    Last post