I think I used a Park headset removal tool. You have to ensure it engages on the inside edge not the edge thats in contact with the BB. It doesn't matter if that edge gets slightly damaged as it is not in contact with the frame. There are probably better tools for this job though.
By inside edge u mean about edge where bb86 cups and threadlock alloy inserts are in contact and to be carefull to dont engage on part where threadlock sleeves are in contacti with the frame i guess?
And can u point me specific tool? Is it this one: https://www.parktool.com/product/head-c ... ry=Headset
"Also removes the PressFit 30 (PF30) bottom bracket units. The PressFit 30 inside diameter is the same as headset cups, and is pressed in the same manner."
Asking because to me dont look like compatible with BB86 cups...
You need the Park BBT90.3 or much better is the Enduro BRT 003 which needs no hammer but is expensive.
I thought the same until i start reading and find out that BB90.3 is for removing BB86 bearings and not cups.
Probably the right tool will be Park RT-1 (95% sure about this), or Park RT-2 (5% for this), or Unior 1681.1
I will appreciate if someone confirm me about this, and if u have opinion whicn one is better Unior or Park will like love to find ur opinions.
Enduro BRT003 is great tool but too expensive for using once ot twice in two-three years, so even i wanted to order i decide that is not worth.
There is anouther similar tool, but also not worth for using once... It's: http://www.ebay.com/itm/TriPeak-Integra ... c42PFU2y_A
For pressing the cups probably i'll use this one: https://www.bike-components.de/de/Cyclu ... l-o300001/
Together with this: https://www.bike-components.de/de/Cyclu ... lo-p33827/