Park Stand - PRS-20

Back by popular demand, the general all-things Road forum!

Moderator: robbosmans

Post Reply
p3dalfaster
Posts: 77
Joined: Tue Jun 16, 2015 10:22 am

by p3dalfaster

Hi Guys,

Question, I am trying to put my PRS-20 together. Inside the Yoke Weldment, there is a plastic sheeth, this makes inserting the Slider Tube Weldment super super tight. Is this sheet supposed to be there, or is it purely some protection for carriage?

Thanks a lot!

:)

User avatar
BRM
Posts: 817
Joined: Sun Mar 16, 2014 3:43 pm

by BRM

too cryptic for me :? , a picture do wonders . . .

btw for these kind of questions youtube often helps you

by Weenie


Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓    Broad Selection ✓    Worldwide Delivery ✓

www.starbike.com



Butcher
Shop Owner
Posts: 1925
Joined: Sun Jan 03, 2010 4:58 am

by Butcher

It's been awhile since I put mine together, but I used the plastic sleeve. Is it absolutely needed? I do not know, but I followed the instructions and it works perfectly.

wobbly
Posts: 296
Joined: Tue Sep 26, 2006 3:50 pm

by wobbly

from memory.....I recall this being a tight fit - I think some gentle "persuasion" and it slid in ok and all parts were absolutely needed. Have faith, hold your nerve and follow the instructions in the box :beerchug:

User avatar
bikerjulio
Posts: 1900
Joined: Fri Dec 11, 2009 10:38 pm
Location: Welland, Ontario

by bikerjulio

lubricant
There's sometimes a buggy.
How many drivers does a buggy have?

One.

So let's just say I'm drivin' this buggy...
and if you fix your attitude you can ride along with me.

http://www.youtube.com/watch?v=GekiIMh4ZkM

p3dalfaster
Posts: 77
Joined: Tue Jun 16, 2015 10:22 am

by p3dalfaster

Cheers for the replies lads - I actually spoke with Park, they said it's needed but are going to send me another anyway "just in case" - good customer service from them. :thumbup:

by Weenie


Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓    Broad Selection ✓    Worldwide Delivery ✓

www.starbike.com



goodboyr
Posts: 1487
Joined: Wed Jan 10, 2007 10:56 pm
Location: Canada

by goodboyr

Just further on this. Make sure you grease inside and outside this sleeve before you install. If you use the stand to wash your bike, the centre steel support tube will rust. Since rust takes up more volume than plain steel, that will freeze everything up. I went to the prs21 which has an anodized aluminum shaft and it has been faultless after countless washes.

Sent from my SM-G900W8 using Tapatalk

Post Reply