ST-RS685 Hood Problems (shimano ultra hydraulic disc)
Moderator: robbosmans
-
- Posts: 58
- Joined: Thu Jan 19, 2017 4:18 am
- Location: Miami
*ultegra.... auto correct
Just built the bike yesterday and it is UN RIDEABLE today. They naturally raise just sitting there and rotate and squirm in your hand! completely useless! Not just irritating but SERIOUSLY DANGEROUS. everything is installed correctly, they just seem like they came out of the mold 5-10% too large for the actual brake/shifters. Ive searched all morning after my hairy ride this AM and it seems like LOTS of people have this problem however I have not found a solution yet!??!?!
Please assist!
Just built the bike yesterday and it is UN RIDEABLE today. They naturally raise just sitting there and rotate and squirm in your hand! completely useless! Not just irritating but SERIOUSLY DANGEROUS. everything is installed correctly, they just seem like they came out of the mold 5-10% too large for the actual brake/shifters. Ive searched all morning after my hairy ride this AM and it seems like LOTS of people have this problem however I have not found a solution yet!??!?!
Please assist!
Last edited by theyoungconnoisseur on Mon Jan 23, 2017 12:16 am, edited 1 time in total.
Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓ Broad Selection ✓ Worldwide Delivery ✓
www.starbike.com
I have something similar with 785, one of fixing points is getting out, but hoods remains still and usable
discussion link on other forum confirms problem
Y07X98080 - hoods from ST-RS685 ($10 on universalcycles)
for a newer ST-RS505 and ST-RS405 shimano even moved bleeding port closer to band clamp so you dont have to uncover hoods
interesting where will be bleeding port on new dura-ace hydraulics ST-R9170 and ST-R9120
discussion link on other forum confirms problem
Y07X98080 - hoods from ST-RS685 ($10 on universalcycles)
for a newer ST-RS505 and ST-RS405 shimano even moved bleeding port closer to band clamp so you dont have to uncover hoods
interesting where will be bleeding port on new dura-ace hydraulics ST-R9170 and ST-R9120
'
I had the same problem last year, but since I bought the hoods second-hand, I just ponied up and bought a new set of replacement hoods. I rode all CX season this year with the new hoods and didn't have a problem.
Madone 9 - https://bit.ly/2Nqedbn
Emonda SLR - https://bit.ly/2UK5FP8
Crockett - https://bit.ly/2Xem4sk
Emonda SLR - https://bit.ly/2UK5FP8
Crockett - https://bit.ly/2Xem4sk
-
- Posts: 58
- Joined: Thu Jan 19, 2017 4:18 am
- Location: Miami
just wrapped the tape over them to hold tight.
Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓ Broad Selection ✓ Worldwide Delivery ✓
www.starbike.com