I'm thinking of stripping the paint on my carbon tubs, they have red and white logos, and I want them all black. How do i do that?
This is the wheels
Strip paint FFWD F5R
Moderator: robbosmans
Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓ Broad Selection ✓ Worldwide Delivery ✓
www.starbike.com
With FFWDs the logos are under a clear coat.
It would be really difficult to remove them.probably easier to sell them and buy new wheels with black logos.
Parlee Z5, Trek Madone, Jonesman Custom
It would be really difficult to remove them.probably easier to sell them and buy new wheels with black logos.
Parlee Z5, Trek Madone, Jonesman Custom
Ozrider - Western Australia
Parlee Z5 XL (6055g/13.32lbs) Trek Madone 5.9 (7052-7500g)Jonesman Columbus Spirit (8680g)
Chase your dreams - it's only impossible until it's done
Parlee Z5 XL (6055g/13.32lbs) Trek Madone 5.9 (7052-7500g)Jonesman Columbus Spirit (8680g)
Chase your dreams - it's only impossible until it's done
You could try permanent marker or just spray them. You could if your brave try and sand the clear coat off. I would do this with a very fine grit.
Xena a demi god among the digital demimonde that is WW community
http://i.imgur.com/hL5v3ai.jpg
https://www.flickr.com/photos/131970499@N02/
http://i.imgur.com/hL5v3ai.jpg
https://www.flickr.com/photos/131970499@N02/
There's plenty of threads here on WW with people stripping expensive framesets with razorblades. I believe it's the best way to strip paint and clear coat. It should be doable on wheels as well, even though the shapes might make it a challenge.
/Martin
/Martin
Samuel Sanchez Gonzalez wrote:Ohh okay! I just knew "plug" was something to put inside a hole... yikes