Bottom bracket for 2016 Cannondale EVO

[wheelzqc]

What is the bottom bracket for the 2016 himod EVO? I took off my crank and their are due. It looks more like two cups not attached together.

[wheelzqc]

So it's really back to BB30 bearings (6806) pressed in the frame ? Nothing to do with PF30 cups.

http://wheelsmfg.com/bb30a-tech-info

Shell inner diameter (ID): 42mm
Two 6806 bearings (42mm OD, 30mm ID) pressed directly in frame and stop at removable snap rings

[nemeseri]

What is the bottom bracket for the 2016 himod EVO? I took off my crank and their are due. It looks more like two cups not attached together.

It's PF30A and it's a fairly new "standard".

[wheelzqc]

Do you have a link? Ive been trying to find an example on the internet from an online store or a company..

[nemeseri]

Do you have a link? Ive been trying to find an example on the internet from an online store or a company..

If you use a hollowgram crankset your best bet is your local cannondale dealer. They can order it for you. I tried to find a shop that carries it online with no luck. I guess the reason is that only the slice and the new hi-mod supersix uses this type of BB.

Aftermarket third party solutions usually only available for shimano, sram gxp and rotor cranksets:
https://www.c-bear.com/en/products/pf30a
http://kogelbearings.mysimplestore.com/ ... ano-cranks

[nemeseri]

So it's really back to BB30 bearings (6806) pressed in the frame ? Nothing to do with PF30 cups.

http://wheelsmfg.com/bb30a-tech-info

Shell inner diameter (ID): 42mm
Two 6806 bearings (42mm OD, 30mm ID) pressed directly in frame and stop at removable snap rings

BB30A != PF30A

The BB30A has been used in the CAAD12 and newer Synapses, while the PF30a is the one they use in the slice and and latest hi-mod supersixes.