EPS Installation Question
Moderator: robbosmans
Looks much better, what did you go for in the end?
Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓ Broad Selection ✓ Worldwide Delivery ✓
www.starbike.com
- ultimobici
- in the industry
- Posts: 4456
- Joined: Sun Nov 21, 2004 2:45 pm
- Location: Trento, Italia
- Contact:
10mm 2:1 heat shrink and a proper heat gun.
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
You can remove the writing on the heat shrink with a bit of acetone and a rag
I've found 8mm shrink is the winner with di and eps, it's just wide enough to get all the wires through and is nice and thing so it give a nice minimal finish
I've found 8mm shrink is the winner with di and eps, it's just wide enough to get all the wires through and is nice and thing so it give a nice minimal finish
- ultimobici
- in the industry
- Posts: 4456
- Joined: Sun Nov 21, 2004 2:45 pm
- Location: Trento, Italia
- Contact:
Thanks. I'll try that
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk