Does the Chris King PF30 sleeve give enough room for Di2 wires?
Going to put a bottom bracket like this om my FF, and is a bit hesitant about having cables rubbing on axle.
Which PF 30 bottom bracket
Moderator: robbosmans
-
- Posts: 725
- Joined: Sun Jan 26, 2014 3:44 am
I would have thought that any sleeve which is of a smaller diametre than the cups of the BB will give enough room for the cables...
Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓ Broad Selection ✓ Worldwide Delivery ✓
www.starbike.com
-
- Posts: 94
- Joined: Wed Sep 16, 2009 10:27 pm
-
- Posts: 829
- Joined: Tue Jan 13, 2009 2:35 am
Slightly off topic, but I just ordered a Wheels Manufacturing BB86/92 bottom bracket, so it is similar in design to the PF30 but just a different size. I went with the Angular Contact bearings as the ceramics were out of stock.
I have not yet installed it as my new frame has not yet arrived, but the quality seems pretty good. Have not had a chance to weigh it either. I went with the Wheels Manufacturing because the angular contact bearings are supposed to be better than the basic Sram steel bearings. And the Sram ceramic is ridiculously priced.
I also like that I can replace just the bearings in the future, which is like $22 for angular contact, and a bit more for ceramic.
(As a side note, I got it really cheap from a buddy and he did not have access to CK parts through his distributor.)
I'll post an update in a few weeks to let you know how it's working.
I have not yet installed it as my new frame has not yet arrived, but the quality seems pretty good. Have not had a chance to weigh it either. I went with the Wheels Manufacturing because the angular contact bearings are supposed to be better than the basic Sram steel bearings. And the Sram ceramic is ridiculously priced.
I also like that I can replace just the bearings in the future, which is like $22 for angular contact, and a bit more for ceramic.
(As a side note, I got it really cheap from a buddy and he did not have access to CK parts through his distributor.)
I'll post an update in a few weeks to let you know how it's working.