Garmin mount for Deda 35mm bars

Discuss light weight issues concerning road bikes & parts.
Post Reply
Posts: 51
Joined: Mon Jan 20, 2014 5:16 pm
Location: The Far East

by mattythemod

New frame coming and new Deda 35 mm handlebars to go on it and need a Garmin mount to fit these O/S bars as the standard clamps for 31,8 bars are too small , I Came across the raceware direct model which uses the 3 d printing method but was wondering if there any other offerings out there .


Posts: 1030
Joined: Thu Mar 28, 2013 4:42 pm
Location: Pa USA

by glepore

Have you looked at the K edge mount that fits under the top cap like an upper spacer? I really like mine, although I'm using it with a Wahoo RFLKT.
Last edited by glepore on Mon Jan 20, 2014 11:58 pm, edited 1 time in total.
Cysco Ti custom Campy SR mechanical (6.9);Cannondale SS Evo Di2 7970 (5.79); Willier Cento Uno Air Di2 9070 (7.0); C40 Mk2 DA 7800 ; Anvil Custom steel Etap;1996 Colnago Technos Record

by Weenie

Posts: 2196
Joined: Tue Nov 11, 2003 9:47 pm
Location: Santa Cruz, California, USA

by eric

Last I looked the Raceware mount was arguably the best one. It's light, holds the garmin securely yet does not break off the delicate tabs, and keeps the unit close to the bars and level with the bars like an SRM head unit. It's in your field of vision (since it's in front of the bars) yet not sticking up into the wind or sticking out visually. Even though it is 3d printed it's strong and not brittle.

User avatar
Posts: 156
Joined: Wed Jun 08, 2005 4:29 pm
Location: London

by LEC135

+1 for the raceware

Posts: 211
Joined: Tue Jul 14, 2009 2:18 am

by project3

+1 im using it for 4 months plus

by Weenie

User avatar
in the industry
Posts: 394
Joined: Fri Jan 23, 2004 6:31 pm

by carbonLORD


Post Reply
  • Similar Topics
    Last post