I have pair of Zipp 404 tubulars from 2011. Considering rebuilding w a powertap g3 hub. It is a 20 spoke rear wheel. Will it be a good build? Dt comp and brass nipples would be fine. I am 63 kg.
Skickat från min Nexus 7 via Tapatalk 2
Rebuild zipp 404 w Powertap g3 hub
Moderator: robbosmans
Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓ Broad Selection ✓ Worldwide Delivery ✓
www.starbike.com
I've done a few of them. If they are Firecrest there are washers in the rims you have to deal with. Other than that it's pretty standard stuff.
That's what I would do.
Sent from my DROID RAZR HD using Tapatalk 2
Sent from my DROID RAZR HD using Tapatalk 2
I just rebuilt my Zipp 404 FC clincher to a Powertap G3 hub. I went with DT Aero Comp spokes to help boost the stiffness over the stock CX-Ray spokes. 2x/2x.
They built easily. Mine did have the oval washers. It was a minor challenge getting the old washers out cleanly but I found that a stack of neodymium magnets made it an easy task.
They built easily. Mine did have the oval washers. It was a minor challenge getting the old washers out cleanly but I found that a stack of neodymium magnets made it an easy task.
Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓ Broad Selection ✓ Worldwide Delivery ✓
www.starbike.com