I have pair of Zipp 404 tubulars from 2011. Considering rebuilding w a powertap g3 hub. It is a 20 spoke rear wheel. Will it be a good build? Dt comp and brass nipples would be fine. I am 63 kg.
Skickat från min Nexus 7 via Tapatalk 2
Rebuild zipp 404 w Powertap g3 hub
Moderator: robbosmans
I've done a few of them. If they are Firecrest there are washers in the rims you have to deal with. Other than that it's pretty standard stuff.
Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓ Broad Selection ✓ Worldwide Delivery ✓
www.starbike.com
That's what I would do.
Sent from my DROID RAZR HD using Tapatalk 2
Sent from my DROID RAZR HD using Tapatalk 2
Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓ Broad Selection ✓ Worldwide Delivery ✓
www.starbike.com
I just rebuilt my Zipp 404 FC clincher to a Powertap G3 hub. I went with DT Aero Comp spokes to help boost the stiffness over the stock CX-Ray spokes. 2x/2x.
They built easily. Mine did have the oval washers. It was a minor challenge getting the old washers out cleanly but I found that a stack of neodymium magnets made it an easy task.
They built easily. Mine did have the oval washers. It was a minor challenge getting the old washers out cleanly but I found that a stack of neodymium magnets made it an easy task.