Tune Mag 170 disassembly
Posted: Thu May 16, 2013 1:04 pm
Can anyone make any sense of the Tune MAG 170 instructions regarding adjusting play with shims?
From what I can tell, you need to measure the protruding axle length on the drive side from the outer bearing recessed in the freehub. Then the instructions say make sure the end cap plus shims is no more or less than 0.2 (aardvarks? I assume mm).
1.I'm not sure quite what that means
2.The axle is so tight in the bearings I'm not sure how to ensure all the 'play' is at the drive end
3.What sort of device do you need to measure? Most regular calipers I've seen wouldn't measure inside the recess of the end cap or the freehub.
Thanks
From what I can tell, you need to measure the protruding axle length on the drive side from the outer bearing recessed in the freehub. Then the instructions say make sure the end cap plus shims is no more or less than 0.2 (aardvarks? I assume mm).
1.I'm not sure quite what that means
2.The axle is so tight in the bearings I'm not sure how to ensure all the 'play' is at the drive end
3.What sort of device do you need to measure? Most regular calipers I've seen wouldn't measure inside the recess of the end cap or the freehub.
Thanks