Page 1 of 1
remove BB30 bearing shields
Posted: Fri Apr 26, 2013 8:38 pm
by PoorCyclist
I use a metal pick to remove the BB30 seal to regrease the bearings inside.
it bends the seal a little, is there a good trick?
I push it back and can't detect any issues.
remove BB30 bearing shields
Posted: Fri Apr 26, 2013 8:38 pm
by Weenie
Visit
starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓ Broad Selection ✓ Worldwide Delivery ✓
www.starbike.com
Re: remove BB30 bearing shields
Posted: Fri Apr 26, 2013 10:17 pm
by rbrtwyn
Most of the seals are reinforced with metal, so just bend them back as straight as possible and you are fine. They have a lip that snaps into place on the bearing, so even if the seal is a little wavy it should be fine.