remove BB30 bearing shields

Discuss light weight issues concerning road bikes & parts.
Post Reply
Posts: 414
Joined: Wed Dec 07, 2011 1:26 am
Location: California's country side

by PoorCyclist

I use a metal pick to remove the BB30 seal to regrease the bearings inside.
it bends the seal a little, is there a good trick?

I push it back and can't detect any issues.

Posts: 253
Joined: Thu Dec 09, 2004 1:57 pm

by rbrtwyn

Most of the seals are reinforced with metal, so just bend them back as straight as possible and you are fine. They have a lip that snaps into place on the bearing, so even if the seal is a little wavy it should be fine.

by Weenie

Post Reply
  • Similar Topics
    Last post