Hi i have eps super record and the front mech shifts superb on the bike stand,but for some reason today the mech out on a ride sometimes would not change up onto the big ring after a few shifts it would go.
What i cant understand is it was only doing it now and again,any suggestions?do i need to re set and start again
Back home on the stand all good again, maybe its just a minor adjustment.
Any info would be good.
Eps super record
Moderator: robbosmans
Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓ Broad Selection ✓ Worldwide Delivery ✓
www.starbike.com
-
- Shop Owner
- Posts: 963
- Joined: Thu Apr 17, 2008 1:07 am
- Location: San Juan, Puerto Rico
- Contact:
Check all connections and make sure they are tight.
Also any humidity on the connectors.
You may want to do a master reset:
Insert the Magnet and hold both mode buttons for 30 seconds.
Remove the Magnet (the Power Unit LED should make a rapid flash green and then shutdown)
Redo the Zero Settings on the rear and front derailleurs.
Make sure you are not getting any diagnostic lights......
Also any humidity on the connectors.
You may want to do a master reset:
Insert the Magnet and hold both mode buttons for 30 seconds.
Remove the Magnet (the Power Unit LED should make a rapid flash green and then shutdown)
Redo the Zero Settings on the rear and front derailleurs.
Make sure you are not getting any diagnostic lights......
- eliflap-scalpel
- Posts: 870
- Joined: Sun May 25, 2008 10:12 pm
- Location: italy
- Contact:
tried ? it worked ?
http://eliflap.it/