Page 1 of 1
BB30 crankset on S-Works OSBB
Posted: Tue Mar 12, 2013 12:39 pm
by sawyer
I know this has come up before, though the input was limited and I'm interested in any further information from people who run a BB30 crank with an S-Works OSBB
We all know that Specialized in their wisdom have complicated things with the OSBB.
I plan to fit an Exogram BB30 chainset to an S-Works Venge using the Delrin cups. Can anyone with this combination chime in to share their experience?
BB30 crankset on S-Works OSBB
Posted: Tue Mar 12, 2013 12:39 pm
by Weenie
Visit
starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓ Broad Selection ✓ Worldwide Delivery ✓
www.starbike.com
Re: BB30 crankset on S-Works OSBB
Posted: Tue Mar 12, 2013 5:36 pm
by aaric
With the delrin cups in, OSBB uses BB30 spacing, and bearings. You should have no special issues using a BB30 crank.
The only possible issue would be frame clearance with the exogram, but that seems very highly unlikely.
And given that specialized has released the crankset on the frame, I think you are fine:
http://cyclelifeusa.com/2012/06/special ... d-edition/
Re: BB30 crankset on S-Works OSBB
Posted: Tue Mar 12, 2013 11:05 pm
by tonytourist
I'm running the SRAM Red Exogram crankset with no issues on my osbb Specialized SL3
Re: BB30 crankset on S-Works OSBB
Posted: Tue Mar 12, 2013 11:18 pm
by UTmtnbiker
I just built up an S-Works SL4 with an Exogram BB30 crankset.
Pretensioner to take out the play and the dust caps/spacers that come with the crankset are all you need.
Re: BB30 crankset on S-Works OSBB
Posted: Thu Mar 14, 2013 4:42 pm
by bikericer
Built just finished building my S-Works Venge with Red BB30 cranks with no issues, Pressfit BB30, dust shields, a spacer or two and the compression ring on the left side (or wavy washer) and it works great. Side note--- That bike is now for sale.
BB30 crankset on S-Works OSBB
Posted: Thu Mar 14, 2013 5:01 pm
by jdp211
When I had my Tarmac, I ran a hollowgram srm on it with no issues.
Re: BB30 crankset on S-Works OSBB
Posted: Wed Mar 20, 2013 10:19 am
by londoncommuter
Apologies if this is a stupid question but I've got an 2012 SL4 on order as well as a SRAM S951 chainset and would love any information on fitting them. The chainset I think is basically BB30 but has a longer axle (they also work in wider BBright frames).
What will I get in the box with the SL4, what's already installed and what else do I need?
Do people use the expoy that Specialized recommend and if so what for? I'd been reading a lot about the Loctite that Cervelo owners use, presumably that would be just as good (641 with 7649 primer)?
Any guidance much appreciated.
Re: BB30 crankset on S-Works OSBB
Posted: Wed Mar 20, 2013 10:19 am
by Weenie
Visit
starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓ Broad Selection ✓ Worldwide Delivery ✓
www.starbike.com