BB30 crankset on S-Works OSBB

Discuss light weight issues concerning road bikes & parts.
Post Reply
Posts: 4470
Joined: Fri Dec 15, 2006 7:45 pm
Location: Natovi Landing

by sawyer

I know this has come up before, though the input was limited and I'm interested in any further information from people who run a BB30 crank with an S-Works OSBB

We all know that Specialized in their wisdom have complicated things with the OSBB.

I plan to fit an Exogram BB30 chainset to an S-Works Venge using the Delrin cups. Can anyone with this combination chime in to share their experience?
Stiff, Light, Aero - Pick Three!! :thumbup:

Posts: 439
Joined: Thu Jun 09, 2011 4:10 pm

by aaric

With the delrin cups in, OSBB uses BB30 spacing, and bearings. You should have no special issues using a BB30 crank.

The only possible issue would be frame clearance with the exogram, but that seems very highly unlikely.

And given that specialized has released the crankset on the frame, I think you are fine:

Image ... d-edition/

by Weenie

Posts: 1151
Joined: Sat Oct 10, 2009 7:13 am
Location: 93306

by tonytourist

I'm running the SRAM Red Exogram crankset with no issues on my osbb Specialized SL3

Posts: 40
Joined: Thu Aug 10, 2006 3:10 pm
Location: Salt Lake City, UT

by UTmtnbiker

I just built up an S-Works SL4 with an Exogram BB30 crankset.

Pretensioner to take out the play and the dust caps/spacers that come with the crankset are all you need.

Posts: 78
Joined: Thu Sep 17, 2009 5:22 pm

by bikericer

Built just finished building my S-Works Venge with Red BB30 cranks with no issues, Pressfit BB30, dust shields, a spacer or two and the compression ring on the left side (or wavy washer) and it works great. Side note--- That bike is now for sale.

Posts: 629
Joined: Fri Feb 12, 2010 4:26 am

by jdp211

When I had my Tarmac, I ran a hollowgram srm on it with no issues.

Posts: 1
Joined: Fri Feb 22, 2013 9:21 am

by londoncommuter

Apologies if this is a stupid question but I've got an 2012 SL4 on order as well as a SRAM S951 chainset and would love any information on fitting them. The chainset I think is basically BB30 but has a longer axle (they also work in wider BBright frames).

What will I get in the box with the SL4, what's already installed and what else do I need?

Do people use the expoy that Specialized recommend and if so what for? I'd been reading a lot about the Loctite that Cervelo owners use, presumably that would be just as good (641 with 7649 primer)?

Any guidance much appreciated.

by Weenie

Post Reply
  • Similar Topics
    Last post