So in other threads there has been angst over the ENVE garmin mount. It just didn't work with the Edge 1000 in landscape mode, and even the smaller models, once you locked it in it would give up the ghost after a while and just spin around.
ENVE has been pretty good about replacing defective units, and then realized that the product required a redesign.
They really came through again, as they were supposed to ship me yet another replacement 3 weeks ago to tide me over until the redesign was finished. At which point they would send me a redesigned unit, all free. So yesterday I get a UPS notification that a package was in the mail to me, and I was understandably upset because I should have had that replacement a week or so ago, not just shipping now.
Customer support responded that they ran out of "defective" ones, and that this was a redesigned model. Since the ball had been dropped with regards to communication, they upgraded the shipping to *overnight*.
So I have in my hands the new and improved model, and I think they've fixed it.http://imgur.com/a/dRuGC
The mount is about 1/2" longer, which should solve the Edge 1000 landscape issues. It does look like you will have to loosen/remove the center screw and reset it 90 degrees CCW then replace the screw to use in landscape mode.
The "face plate" is also thicker, and the little nub to hold the two pieces in alignment is now buried (see above). I'm confident this will resolve the spinning issue.
While it should have been tested more thoroughly, their support did a really good job of keeping me happy and addressing the issue.