Page 1 of 1
Help to sand Easton carbon components - Logos take off
Posted: Sat Nov 03, 2012 2:40 pm
by Naturel
Hello,
I would like to buy Easton seatpost EC90 Zero, stem EC90 SL and handlebar EC90 SLX3 in UD matte carbon,
Is there someone who knows how to take off the logos?
Thank You for your help.
Re: Help to sand Easton carbon components - Logos take off
Posted: Sat Nov 03, 2012 4:36 pm
by Gregorio
Try acetone....use rubber gloves. If that doesn't work just use some fine grit sand paper.
Re: Help to sand Easton carbon components - Logos take off
Posted: Sat Nov 03, 2012 4:36 pm
by Weenie
Visit
starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓ Broad Selection ✓ Worldwide Delivery ✓
www.starbike.com
Re: Help to sand Easton carbon components - Logos take off
Posted: Sat Nov 03, 2012 4:47 pm
by Rick
MEK (methyl ethyl ketone) will wipe the loggos right off of 3T stems. You might try that. Wear gloves and work outside or in good ventialtion.