Weight Weenies
http://weightweenies.starbike.com/forum/

Cannondale Headset help
http://weightweenies.starbike.com/forum/viewtopic.php?f=3&t=108694
Page 1 of 1

Author:  dane476 [ Sat Oct 27, 2012 8:29 pm ]
Post subject:  Cannondale Headset help

Hi
I've got a cannondale carbon six frame, just brought it to build a training bike, and have no idea on the headset, currently has a cane creek is24 but can't find anything about it anywhere, had the bearings out and both top and bottom say 1 1/8, 36 x 45, is this a standard integrated system?? Just checking before I buy anything? Which headsets would be compatible??
Cheers

Author:  Weenie [ Sat Oct 27, 2012 8:29 pm ]
Post subject:  Cannondale Headset help


Author:  em3 [ Sat Oct 27, 2012 8:48 pm ]
Post subject:  Re: Headset help

http://www.canecreek.com/headset-finder

Author:  dane476 [ Thu Nov 01, 2012 6:42 pm ]
Post subject:  Re: Headset help

Anyone else??? Cane creek doesn't have the six on there

Author:  thisisatest [ Thu Nov 01, 2012 7:29 pm ]
Post subject:  Re: Headset help

36*45 is standard I.S.. if it also says 41.8, or measures 41.8mm as the outside diameter, then it's an "in-betweener", a mix of I.S. and Campy fitment. Sweet, huh? It's a way some companies have been making bearings to install into Campy-fit frames, but to use I.S. crown race, compression ring, top cone...
So first, measure the diameter of the largest part of the hole in the head tube. If it's 41.0mm, then it's all IS. Get an IS headset or just the bearings.
If it's 41.8mm, the FRAME is campy-fit. If you're replacing the whole headset, just get a campy-fit headset, no problems. If you were hoping to just replace bearings in this situation, it may be more trouble than its worth.

Page 1 of 1 All times are UTC+01:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/