Page 2 of 2
Re: Gunmetal Planet X Ultra Light CNC brakes...
Posted: Wed Aug 29, 2012 8:02 am
by HillRPete
Can anyone confirm they work for wide rims, like Zipp and Hed? Thanks.
Re: Gunmetal Planet X Ultra Light CNC brakes...
Posted: Wed Aug 29, 2012 8:02 am
by Weenie
Visit
starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓ Broad Selection ✓ Worldwide Delivery ✓
www.starbike.com
Re: Gunmetal Planet X Ultra Light CNC brakes...
Posted: Thu Aug 30, 2012 7:28 pm
by JourneyLightly
madmole wrote:They are dual pivot and have always been. One pivot is the mount bolt and the other is the wheel on the end of the cam arm
I received a set last night. They're not actually dual pivot. Both caliper arms pivot around a single bolt, versus having a second pivot bolt for one of the arms. The cam arm changes the leverage as the calipers close.
On my scale, one brake w/pads and hardware weighs 105g, versus 135g for a 2011 SRAM Red w/pads and hardware.
Re: Gunmetal Planet X Ultra Light CNC brakes...
Posted: Sat Dec 28, 2013 4:11 pm
by Elrey
I need to bump this.
wassertreter wrote:Can anyone confirm they work for wide rims, like Zipp and Hed? Thanks.
I got same question.
Re: Gunmetal Planet X Ultra Light CNC brakes...
Posted: Sat Dec 28, 2013 4:55 pm
by btompkins0112
I have run them with Archetypes and XC279s without issue. Can't speak for wider rims than that though...however, I felt like there would have been room.
Re: Gunmetal Planet X Ultra Light CNC brakes...
Posted: Sat Dec 28, 2013 5:10 pm
by Elrey
Great. Thanks!
Re: Gunmetal Planet X Ultra Light CNC brakes...
Posted: Sun Jan 05, 2014 10:27 pm
by crujones78
Not to start a whole new thread with a related topic, but I'll be receiving these brakes this week.
Any tips or suggestions for the install, if they are much different than the SRAM brakes I'll be replacing?
Thanks.