mavic yksion griplink/powerlink tubular 1/2 off

Discuss light weight issues concerning road bikes & parts.
Wookieopolis
Posts: 118
Joined: Tue Jun 07, 2011 4:28 am
Location: Berkeley, CA

by Wookieopolis

Rc32, are you scraping the base tape on the Thai made Yksion tubulars? I just picked up a pair and they seem to have quite a thick layer of latex on the base tape.

by Weenie


User avatar
rc32
Posts: 200
Joined: Sun Jan 20, 2008 6:40 pm
Location: Here during the week, home on the weekends

by rc32

On the Thai ones, no.

I tried scraping off a bit and didn't get anywhere so I just glued them like that. Haven't had any problems with them so far. I've raced them a couple of times and they've been holding up just fine.

I think I might end up swapping them for something else when the race season here gets fully underway but for these shorter early season races they get the job done. I have some Corsa Evo Slicks, Bontrager XXXLites and some "Schwalbe Ultremo" labeled Veloflex Carbons that I might glue to the Corimas for the later races.

Post Reply
  • Similar Topics
    Replies
    Views
    Last post