Are there any similar hole covers for rims?

And are they good?

weight is pretty low

Thanks

_________________
http://kavitec.blogspot.com/

click this! http://www.youtube.com/watch?v=jqfFdCWAH5I&list=UUEtgd6K9EDGmoSE2YYipQgQ&index=20

Those are the only ones I know of. I don't know why you'd want anything else though, cost-weight ratio is about the best out there and I haven't read a bad experience with them. Make sure you get the right size though.

Thanks

_________________
http://kavitec.blogspot.com/

click this! http://www.youtube.com/watch?v=jqfFdCWAH5I&list=UUEtgd6K9EDGmoSE2YYipQgQ&index=20

I have them on my wheels and they are good. The only additional recommendation I'll give is to use a piece of rim tape over the valve hole, I learnt the hard way by going through a few latex tubes. Since I've put a small piece of rim tape over the valve hole with a small hole cut for the valve to stick through I've had no more flats.

good point . now i put carbon/kevlar composite covers. but veloplugs weight just little more. on kinlun rims valve hole is very tight and no flats for now. but i will put some soft tape on edges of the hole.

cheers

_________________
http://kavitec.blogspot.com/

click this! http://www.youtube.com/watch?v=jqfFdCWAH5I&list=UUEtgd6K9EDGmoSE2YYipQgQ&index=20