Really simple one this and of course it may be I am chasing a unicorn here but was wondering aabout any advice to do with making the rubber hoods on sram brifetrs fit well after removing them to regrese the double tap mechs and then put them back on...

I had heard some shops use hair dryers? Any comments or advice?

_________________
Many Thanks

Martin Dallaghan

alcohol and wipe off the lever body and the inside of the hood.

Heat them up before you put them on. I use warm water and then dry them off before installing.

_________________
I'm so rubbish at this.

+1 on the hair dryer.

_________________
Cervélo S2 2012 Red
Great minds think alike... sadly, so do the mediocre ones.

this will get the job done in no time, trust

Horses urine mixed with breast milk will get them clean