Soul Prodigy hub bearing adjustment

Back by popular demand, the general all-things Road forum!

Moderator: robbosmans

Post Reply
gilesharrison
Posts: 226
Joined: Tue Nov 04, 2008 6:44 pm

by gilesharrison

Quick question. I'm struggling to set the bearing preload correctly on my Soul Prodigy V3 rear hub.

The rear axle has a screw on end cap on the drive side. If I screw this right down (until it bottoms out) then there is too much bearing preload and the axle will barely turn. If I don't screw it down fully, it works loose - I could use a bit of thread lock but that doesn't seem right!

Any advice would be appreciated. Thanks.

soulbike
in the industry
Posts: 112
Joined: Sat Nov 17, 2007 4:35 am
Location: Singapore
Contact:

by soulbike

Hi Gilles,

The Prodigy hub can't be pre-loaded, as the entire assembly is spaced. What is actually going on in your hub is the washer between the freehub and hub body bearings is deformed and getting stuck on the axle. Remove the washer, flatten it with a mallet and file the inside to get it to not bind on the axle and you should be able to tighten the endcaps without any binding.

by Weenie


Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓    Broad Selection ✓    Worldwide Delivery ✓

www.starbike.com



gilesharrison
Posts: 226
Joined: Tue Nov 04, 2008 6:44 pm

by gilesharrison

I did exactly what you described and it worked perfectly. The hubs now spins smoothly with the end caps fully tightened.

Many thanks.

Post Reply