Weight Weenies
* FAQ    * Search    * Trending Topics
* Login   * Register
HOME Listings Blog NEW Galleries NEW FAQ Contact About
It is currently Sat Apr 30, 2016 2:07 pm
Recently the board software has been updated and there are some known bugs/failures:
- Avatars are currently not being displayed
- Tapatalk connection is currently broken

Those bugs will be fixed ASAP (next few days) as they are unfortunately more serious than expected.

If you find more errors please post it here: http://weightweenies.starbike.com/forum/viewtopic.php?f=7&t=139062

All times are UTC+01:00

Post new topic  Reply to topic  [ 3 posts ] 
Author Message
PostPosted: Thu Jun 28, 2012 10:15 pm 

Joined: Tue Apr 05, 2011 7:41 pm
Posts: 630
An annoying creak from a new centaur power torque chainset with associated ball ache tooling and stupid wave washers is leading me toward switching out the chainset only to Shimano Ultegra or DA, will there be any issues with compatibility re chain and cassette if I do this? anyone run similar?

PostPosted: Thu Jun 28, 2012 11:02 pm 

Joined: Thu Jun 28, 2012 10:52 pm
Posts: 216
Location: eNZed
On my Look381i since early April 2012: CX-70 46/36 cylcocross chainset with Athena levers & rear der, 02 Chorus 10spd front der, Chorus 11-23 cassette and KMC gold 11spd chain. No problems :wink:

Last edited by shimmeD on Thu Jun 28, 2012 11:18 pm, edited 1 time in total.

PostPosted: Thu Jun 28, 2012 11:18 pm 
in the industry

Joined: Sat May 12, 2012 7:25 pm
Posts: 2510
Location: Glermsford, Suffolk U.K
Power torque need not creek. Mine does not.

Cheack the bearings are running smooth. Check for play in the crank arms. Replace bearings if necessary.
Face the BB sheel and tap the threads. Ensure cups are coppasliped and torqued to campag specs. Frame must within campag spec i.e shell width 67.2-68.8mm. Ensure the NDS crank bolt is tight. The special and expensive tools to remove the crank arm are a pain but is a beautiful crankset so I don't mind. Also I have not tried the Park tool power torque tools but I can atest to the quality of the more expensive Cyclus Power torque tools. These are brilliant.

Make sure you pedal threads are not dry the creak could be that.

Don't give up on campag the power torque system is quite good just not DIY freindly due to expensive service tools.


Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 3 posts ] 

All times are UTC+01:00

Who is online

Users browsing this forum: rbrtwyn, superdx, wingguy and 29 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Limited