Weight Weenies

If anyone has a Dogma2 Electronic would you be able to tell me if there is anyway to mount an SRM cadence sensor under there without gluing (ie is there a threaded screw hole for a traditional cable guide) Picture would be nice too if you could!
Many thanks in advance!

We have used the stock SRM style mount but used double sided tape. It sounds pretty hokey but it's secure.

Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓    Broad Selection ✓    Worldwide Delivery ✓

www.starbike.com

Have used double sided tape on my dogma for 6 months without any problems, go for it!

/Roberto

Thanks guys... just exploring some options.... another site I found recommended 3M Marine Sealant as well..
Did you guys just use plain old double sided tape then?? Nothing extreme??

Yupp!

Nothing special just standard tape.

Skickat från min GT-I9100 via Tapatalk 2

Thanks!!!

No problems

If you want peace of mind, can always opt for the 3M VHB tape. Look for the "outdoors" application version that's grey in colour.

I used it to glue the normal cadence sensor to my crank. Has held for the past 4 years!

Why would you not toss the SRM thing and just glue-on a rare-earth magnet to the frame?

Saw the 3M tape as well in a search.

I don't want to glue personally.. but thats just me... it is a valid option though!

Just tossing around a build right now and looking at how much the bank account would suffer!!

I remember seeing a photo of Wiggin's time trial bike a while back. It showed a rare earth magnet glued to the down tube for the SRM. Looked to be a very clean setup. Here's the photo:

Hmm that with the 3M tape would be even better....

No, it wouldn't.

If you don't want to have any glue residue on the frameset, just steal your wife/gf's hot glue gun and use that. Make sure you have a good bit of a 'bead' around the magnet and it will stay-put just fine. It will come-off without any affect to your frameset.

Geoff wrote:No, it wouldn't.

If you don't want to have any glue residue on the frameset, just steal your wife/gf's hot glue gun and use that. Make sure you have a good bit of a 'bead' around the magnet and it will stay-put just fine. It will come-off without any affect to your frameset.

Sounds like you have not used VHB tape before ??

Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓    Broad Selection ✓    Worldwide Delivery ✓

www.starbike.com

The VHB tape is too sticky. You need to be able to glue-on the magnet, test it and reposition it, if necessary...