Pressfit bearing question and Hollowgram
Posted: Thu Jun 07, 2012 3:49 am
I have seen it recommended more then once and still have not gotten an answer as to why.
Why is it recommended to remove the seal behind the bearing shield? Is this simply being done to reduce drag or is there some other good reason.
I don't see the point in removing since your typical catridge type bearing seals are not intended to prevent water intrusion and bearings will not last very long if you get caught out in the rain.
Why is it recommended to remove the seal behind the bearing shield? Is this simply being done to reduce drag or is there some other good reason.
I don't see the point in removing since your typical catridge type bearing seals are not intended to prevent water intrusion and bearings will not last very long if you get caught out in the rain.