Dura Ace vs Ultegra rear hub measurements
Moderator: robbosmans
Are the DA7900 rear hub measurements the same as the Ultegra 6700? My spoke calculator only knows about the DA. Thanks.
Bikes: Raw Ti, 650b flatbar CX
Dura ace hubs are significantly different from Ultegra and other levels. 6700 should be the same as 6600.
"http://www.shimano.com/publish/content/global_cycle/en/us/index/tech_support/tech_tips.download.-Par50rparsys-0034-downloadFile.html/07)%20Hub%20Specs.pdf"
"http://www.shimano.com/publish/content/global_cycle/en/us/index/tech_support/tech_tips.download.-Par50rparsys-0034-downloadFile.html/07)%20Hub%20Specs.pdf"
Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓ Broad Selection ✓ Worldwide Delivery ✓
www.starbike.com
-
- Posts: 194
- Joined: Fri Aug 27, 2010 4:22 pm
I built my training wheels up with a 6700 rear hub and came up with these measurements -
Centre to NDS Flange - 34mm
Centre to DS Flange - 17mm
Spoke hole circle - 47mm (outer to outer, centre to centre would be 45mm)
Spoke hole diameter - 2.3mm
Weight - 354g
Hope that helps.
Alex
EDIT - Interesting that it's different. I'm wondering if I measured in a different way to Shimano as I measured centre to the near side of the flange. If you add the 3mm for flange width you get a similar result to the Shimano tech doc for 6600.
Centre to NDS Flange - 34mm
Centre to DS Flange - 17mm
Spoke hole circle - 47mm (outer to outer, centre to centre would be 45mm)
Spoke hole diameter - 2.3mm
Weight - 354g
Hope that helps.
Alex
EDIT - Interesting that it's different. I'm wondering if I measured in a different way to Shimano as I measured centre to the near side of the flange. If you add the 3mm for flange width you get a similar result to the Shimano tech doc for 6600.
Ok thanks everyone. I found another place that had the FH-6700 same as the 6600 from the tech docs, so I went with that. Fingers crossed ...
Bikes: Raw Ti, 650b flatbar CX