praxis works + SRAM red, crank pin touching
Posted: Wed Mar 28, 2012 5:42 am
I installed on Praxis works clover chainrings 50/34T on SRAM Red crank.. I am definitely not the only person with this combination as I have seen pictures, not sure if it was a compact 50T with smaller ring size though.
All seems well but I noticed the crank pin that protects from overshift is touching the crank arm. I cannot fit a piece of paper through it. I am sure the original had more clearance.
It does not seem to push the chainring out of alignment or anything. Do you think it is a problem? I would hate to have to take it off and grind the pin down if it is not an issue, I hope this won't make any unwanted noise.
All seems well but I noticed the crank pin that protects from overshift is touching the crank arm. I cannot fit a piece of paper through it. I am sure the original had more clearance.
It does not seem to push the chainring out of alignment or anything. Do you think it is a problem? I would hate to have to take it off and grind the pin down if it is not an issue, I hope this won't make any unwanted noise.