I have just purchased 510 and done two rides on this and discovered a major flaw with the recording of speed. The speed seems to be inconsistent and dropping at regular intervals almost consistently over the whole ride. I have updated to the latest firmware already 2.70, and cannot figure for the life of me after searching google why this would be happening, my edge 200 was faultless and even the iphone app was more consistent with speed recording

I have also set GPS to GLONAS.

Take a look at these....

A friends edge 510 speed recording, normal for everyone....



Now my speed recording thats affecting alot of data recording, Garmin upload said 18.3 miles ridden strava uploaded it as 20.4miles, garmin average speed 14.9mph and strava 16.1mph average, calories was also incorrect!!



and zoomed in on a segment....




can anyone explain whats going on here and what could I do to sort this? I cant find any other posts with the same problem.

_________________
Madone Five Series 2013
Shimano Dura-Ace 9000
Mavic Cosmic SLE 2013

Does it do this on anything else on garmin connect or any other prog as well as strava?
Livetracking and your phone data connection?

Did you charge it properly first?

_________________
Official cafe stop tester

http://www.scarletfire.co.uk/2013/06/ho ... on-strava/

Go to the 20% boost example

All digital cheating aside though, I vaguely remember hearing of someone using an Ant+ speed sensor and it causing troubles like that. Garmin said they thought there was a bug and it was having trouble deciding between GPS and the sensor's speed. Are you using a speed sensor or just relying on GPS speed?

What are you using to upload it to Strava? Straight from the Garmin on Strava's site? I have seen Strava make a mess of files uploaded through various different programs.

Maybe try calling Garmin? They've always been good on the phone with my customers in North America.

Appears it must be a but when auto stop is set to custom speed......dont try it...

_________________
Madone Five Series 2013
Shimano Dura-Ace 9000
Mavic Cosmic SLE 2013

I hope you're climbing a hill with a ride that short and slow

_________________
"Ride till I die, well not really I'm too young to die"

The New: BH http://weightweenies.starbike.com/forum/viewtopic.php?f=10&t=117760
The Old: Trek http://weightweenies.starbike.com/forum/viewtopic.php?f=10&t=110051

I've experienced the same issue. I don't think it depends on the auto stop, because mine is not set at custom speed.
I used:
GPS+Glonass
No speed/Cadence sensor
1s recording
SRM
HR
Strava upload straight from the 510's .fit file

I've no idea of the how the twin positioning system's work on the 510.
But in general, if data is gathered from two sources, then the joining of them can result in glitches like this. Of course it should not be eliminated by the firmware.

That happened to me a few moths back. Ended being a bad speed/cadence sensor. First try to reset the sensor and make sure the magnet is place close enough. On rides with the speed jumping around I would just disconnect it and use GPS. Try emailing Garmin for a new cadence sensor, it will take a long time with their excuses and make you do lots of stuff before they send you a new one, but it will happen.

Pivens, I hope that is not your ECG...